https://pslperformance.co.uk//wp-content/uploads/2021/07/ST225-DYNO-PSL-scaled-600x600.jpg

Stage 1

A factory ECU calibration remap taking the factory settings and maps and recalibrating them to their set limits whilst keeping within the standard parts tolerance as well as maintaining the use of any GPF and/or EGR left in place.

Additional Extras

Speed Limiter Removal Applying our speed limiter removal will switch off any factory vehicle speed limit completely.
Stop/Start Off Applying our start/stop system off will turn off the factory start/stop function.

Stage 2

Breaking the rules - To take a petrol engine and ECU to the next level and beyond the stage 1 remap requires stage 2 hardware.

Additional Extras

Decat O2 Removal Solution Applying this solution when you have a decat exhaust system fitted. This will eliminate any diagnostic trouble codes and functions that would normally be trigger from removing the factory cat
Cold Start Off Applying our cold start off solution will fully remove the cold start function stopping the increased idle speed. This function is typically used to heat the factory CAT. The engine will start and resume the normal idle speed.
GPF/OPF Removal Applying our GPF/OPF Gasoline Particulate Filter when fitting a high flow race exhaust system which will eliminate any diagnostic functions and trouble codes that will be caused by removing it.
Pops and Bangs Burbles Applying our pops and bangs burble can add huge bangs and flames, crackles on overrun and hard cut RPM limiter. We can set it up to as aggressive as you would like it and at what ever RPM range you would prefer.
https://pslperformance.co.uk//wp-content/uploads/2021/07/20180406_123841-1-scaled-600x200.jpg

Hardware Required

Full exhaust system upgrade
Intake system upgrade
Intercooler upgrade
High flow 100/200 cell sport cat or decat
Clutch and flywheel upgrade
DSG TCU stage 2 (If applicable)

Stage 3

https://pslperformance.co.uk//wp-content/uploads/2021/07/20210526_120047-scaled-1920x300.jpg

A factory ECU calibration remap taking the factory settings and maps and recalibrating them to their set limits whilst keeping within the standard parts tolerance as well as maintaining the use of any GPF and/or EGR left in place.

Additional Extras

Switchable Maps Apply our switchable maps solution applies a custom code enabling switchable maps for power levels via the pedals or stalk controls. This is ECU dependent.
Launch Control Applying our launch control solution will add a vehicle launch function for optimum take off.

Hardware Required

Stage 2 Hardware
Turbo upgrade
Injector upgrade
Fuel pump upgrade
DSG TCU stage 3 (If applicable)

Pricing

STAGE 1

  £336 Inc VAT

STAGE 2

  £400 Inc VAT

STAGE 3+

  £POA